Le Chai LM78/1 Notice D'utilisation page 149

Setting the Temperature Control
•
The unit has two separate temperature zones. The temperature of both zones can be set between
5ºC and 20ºC (41ºF and 68ºF). It can be used as a wine maturing cabinet or a wine
serving cabinet. For maturing wine, the recommended temperature setting ranges of both zones
should be between 11ºC and 14ºC (52ºF and 57ºF). For serving wine, the recommended
temperature setting range of UPPER/LEFT zone should be between 5ºC and 10ºC (41ºF and
50ºF) which is ideal for serving champagne & white wine and the recommended temperature
setting range of LOWER/RIGHT zone should be between 15ºC and 20ºC (58ºF and 68ºF)
which is ideal for serving red wine.
• When the unit is plugged in for the first time, the unit will power up automatically to the preset
defaults. The preset temperature at the factory for UPPER/LEFT temperature zone is 8ºC (46ºF )
and for LOWER/RIGHT temperature zone is 12ºC (54ºF ).
Touch the Setting Selector
•
use the UP and DOWN keys to set the internal temperature as required. When you touch either
key at the first time, the display will show the last temperature set previously.
IMPORTANT: For non-twin wine conditioning system, the temperature set for the LOWER
•
temperature zone must always be just as high as or higher than that in the UPPER temperature
zone.
•
The temperature will increase 1ºC/1ºF if you touch the UP key once, or the temperature will decrease
1ºC/1ºF if you touch the DOWN key once. The display flashes while you make the setting.
• The set temperature will temporarily flash in the display for 5 seconds after the temperature has been
set. Then the display shows the current inner temperature again.
To view the set temperature at any time, touch the Setting Selector
•
temporarily flash in the display for 5 seconds. Then the display shows the current inner temperature
again.
SETTINGS MODE
Certain settings on the wine cellar can only be selected in settings mode.
Touch and hold the UP key for 5 seconds to enter and leave Settings mode. The appliance will leave
Settings mode automatically after approximately one minute.
ºF/ºC Selection
� Lightly touch and hold the UP key for 5 seconds to enter Settings mode.
� Use the UP and DOWN keys to select the temperature display setting in Fahrenheit or Celsius degree.
� Touch and hold the UP key for 5 seconds to confirm the selection.
Display Brightness
▪ Lightly touch and hold the UP key for 5 seconds to enter Settings mode and then touch the POWER
key once.
▪ Use the UP and DOWN keys to select the brightness of the display when the door is close. When the
door is open, the display brightness returns to its normal level.
d0: off
d1: dimmest setting (default)
d2: medium setting
d3: brightest setting
▪ Touch and hold the UP key for 5 seconds to confirm the selection.
until the temperature you want to set is flashing. Then you can
key, the set temperature will
EN-149