Le Chai LM78/1 Notice D'utilisation page 141

Shelves
To prevent damage to the door seal, make
sure the door is open before pulling the
shelves to install or remove the bottles.
For easier access to the contents of shelves
you need to slide the shelf outward about
1/3 however they are designed with a
stop on each side to prevent the bottles
from falling.
To remove or position the shelves, move the
shelf to the position where the notch of
the wooden shelf is exactly under the
plastic rack stop and then lift it up and
out.
DOOR OPENING MECHANISM (PUSH-AND-OPEN DOOR FUNCTION) (on some models)
The push-and-open door function (if your model supplied with it) is activated when the unit is powered.
To open the door, push the door slightly inwards on the top left position for the right hinge model (the
top right position for the left hinge model) and then release it again. The unit will beep once to
confirm the action. The door will be opened approx.2~7cm by the push rod. Then the door can be
fully open manually. The push rod will return to its initial position after 3 seconds automatically. And
the unit will beep once again and it is ready for next opening action.
NOTE:
- The door will close again automatically after approx. 3 seconds if it has not been fully opened
manually for models with automatic door closing function.
- Do not block the door or hold on it while it is opening. If the door is blocked or held during opening,
the door opening mechanism and the door will be damaged. The loud and repeated cracking noises
will be heard.
- Do not push the push rod in or hold on to it during closing. If the push rod is blocked during closing, it
will no longer be able to reach its initial position. In the initial position, the push rod is flush with the
front of control panel. In order to set the push rod back in its initial position, disconnect the appliance
from the mains, wait for approx. 10 seconds and plug it back in again. The push rod will return to its
initial position.
- The system is not triggered immediately after the door is closed. Allow 3 seconds and try again. This
is not a system failure.
The door on the unit is sensitive to pressure. The pressure sensitivity to open the door is possible to
adjust as following steps:
•
Open the door.
•
Rotate the screw on the top middle of door counterclockwise to
increase the sensitivity and clockwise to decrease the sensitivity.
•
Close the door and check if it is correctly adjusted. Rotating the
screw counterclockwise too much can cause the door to open
automatically even without pushing or just closing the door hard.
In reverse rotating the screw clockwise too much can cause the
door not to open even with heavy pushing.
EN-141