Publicité
Les langues disponibles
Les langues disponibles
DEFROSTING THE REFRIGERATOR
The refrigerator defrosts fully automatically.
While the cooling is running, beads of condensation
or hoarfrost form at the back of the refrigerator.
This is normal. It is not necessary to wipe off the
condensation or frost. The rear panel defrosts
automatically. The condensation runs into the
condensation channel and is conveyed to the
compressor from where it evaporates.
Note: Keep the condensation channel and drainage hole clean, so that the
condensation can run out.
DEFROSTING THE FREEZER COMPARTMENT
A layer of frost in the freezer will impair refrigeration of the frozen food and
increases power consumption. Remove the layer of frost regularly.
Do not scrape off frost or ice with a knife or pointed object. Doing this may
damage the refrigerant tubes.
1.
Remove the frozen food and place temporarily in a cool location.
2.
Disconnect the appliance from the mains socket.
3.
To accelerate the defrosting process, place a pan of hot water on a stand in the
freezer.
4.
Wipe up condensation with a cloth or sponge.
5.
Wipe dry the freezer compartment.
6.
Plug in the appliance and adjust the temperature control knob as desired.
7.
Put the frozen food back in the freezer.
Problem
The device does not
work.
FREQUENTLY ASKED QUESTIONS
Solution
•
Check connection of power cord to power source.
•
Check that the temperature controller is not in the 0
position.
•
Plug in unit.
•
Use proper voltage.
WWW.PRIMO-ELEKTRO.BE
73
Publicité
