Publicité
Les langues disponibles
Les langues disponibles
64 www.electrolux.com
9.2 Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.
9.3 External cleaning
Clean the appliance with a moist soft
cloth.
10. TROUBLESHOOTING
The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solution
to the problem.
With some problems, the display
shows an alarm code:
•
- The appliance does not fill with
water.
Problem
You cannot activate the appli-
ance.
The programme does not start.
The appliance does not fill with
water.
6.
Make sure that the filter (B) is cor-
rectly positioned under the 2 guides
(C).
7.
Assemble the filter (A) and put it back
in filter (B). Turn it clockwise until it
locks.
An incorrect position of the filters
can cause bad washing results
and damage to the appliance.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.
•
- The appliance does not drain the
water.
•
- The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the checks.
Possible solution
Make sure that the mains plug is connected
to the mains socket.
Make sure that there is not a damaged fuse in
the fuse box.
Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or
wait for the end of the countdown.
Make sure that the water tap is open.
Make sure that the pressure of the water sup-
ply is not too low. For this information, con-
tact your local water authority.
Publicité
