Wine Cell'R Diamond Serie Manuel D'instructions page 10

Reversing the door (WC166SSDZ6 & WC181SSSZ6)
Before you start
Make sure the wine cabinet is level. Seal the shelves with tape to prevent movement during
the process. The door of this appliance can be installed to open on the left or right side. To
reverse the movement of your wine cabinet door and open it on the opposite side, please
follow the instructions and diagram below.
1. Lift the hinge cover (1) and the
hinge cap (2) with a flathead
screwdriver.
screwdriver,
screws (3a) and remove the top
hinge (4). You can now lift the door
(5) from the lower hinge and set it
aside. Be careful not to lose the
washer (11) between the lower
hinge and the door. You will need it
later. Also remove the plug from
the locking hole (6) and the screws
(7) and (8) from the top of the
door. The locking cap can be
removed with a small flathead
screwdriver.
2. Using a Phillips head screwdriver,
loosen the screws (3b) to remove
the metal rod from the hinge (9) at
the bottom of the door. Turn the
door 180° (clockwise) so that the
top is now the bottom and vice
versa. Attach the metal rod of the
bottom hinge (9) to the bottom
corner of the door and secure it with
the screws (3b).
3. Using a flat-head screwdriver, lift
off the lower hinge cover (12). Using
a Phillips head screwdriver, loosen
and remove screws (3c) and (13)
and lower hinge (10)
10
Using a Phillips
loosen the hinge