Publicité
Steps
1. Remove the (#6-32) screw that secures the 2.5-inch hard-drive assembly to the hard-drive and optical-drive bracket.
2. Disconnect the data and power cables from the connectors on the hard drive.
3. Lift and slide the 2.5-inch hard-drive assembly away from the hard-drive and optical-drive bracket.
4. Turn over and place the 2.5-inch hard-drive assembly on a flat surface.
5. In a reverse sequential order (4>3>2>1), remove the four (#6-32) screws that secure the 2.5-inch hard drive to the hard-drive cage.
6. Slide and remove the 2.5-inch hard drive from the hard-drive cage.
Installing the 2.5-inch hard drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the 2.5-inch hard drive and provides a visual representation of the installation procedure.
Steps
1. Align and slide the 2.5-inch hard drive into the hard-drive cage.
2. In a sequential order (1>2>3>4), replace the four (#6-32) screws to secure the 2.5-inch hard drive to the hard-drive cage.
3. Align and slide the hard drive assembly into the hard-drive and optical-drive bracket.
4. Replace the (#6-32) screw to secure the 2.5-inch hard drive assembly to the hard-drive and optical-drive bracket.
5. Connect the power cable and data cables to the connectors on the 2.5-inch hard drive.
Next steps
1. Install the
front
cover.
2. Install the
left-side
cover.
3. Follow the procedure in
Retrait du disque dur de 3,5 pouces
Prérequis
1. Suivez la procédure décrite dans la section
2. Retirez le
panneau latéral
3. Retirez le
capot
avant.
À propos de cette tâche
L'image suivante indique l'emplacement du disque dur de 3,5 pouces et fournit une représentation visuelle de la procédure de retrait.
After working inside your
computer.
Avant d'intervenir à l'intérieur de votre
gauche.
ordinateur.
Retrait et installation de composants
15
Publicité
