Replacing The Battery In The Remote Control - Yamaha TSX-100 Mode D'emploi

Remote control
Problem
The remote control does not
work properly.

■ Replacing the battery in the remote control

Change the battery when the operation range of the remote control decreases.
Use a straight pin to remove
the cover.
Notes
• Insert the battery according to the polarity markings (+ and –).
• If the battery runs out, immediately remove it from the remote control to prevent an explosion or acid leak.
• If a battery starts leaking, dispose of it immediately. Be careful not to let the leaking battery acid touch your skin or clothing.
• Before inserting a new battery, wipe the compartment clean.
• Dispose of batteries according to your regional regulations.
Cause
The remote control may be operated
outside its operation range.
The remote control sensor on this unit
may be exposed to direct sunlight or
lighting (inverted fluorescent lamps).
The battery may be worn out.
There are obstacles between the sensor
of this unit and the remote control.
Replace the battery with
a new CR2025 battery.
Troubleshooting
Solution
For information on the remote control
operation range, refer to "Using the
remote control" (☞ P. 5).
Change the lighting or orientation of this
unit.
Replace the battery with new one (see
below).
Remove the obstacles.
Close the cover.
29
En