Ipod; Radio Reception - Yamaha TSX-100 Mode D'emploi

iPod

Status message
Not support
The iPod is connected
Unplugged
Checking

Radio reception

■ FM/AM
Problem
The preset selecting function
(☞ P. 17) does not work.
The preset station settings
have been cleared.
■ FM
Problem
Too much noise during stereo
broadcast.
Even with an outdoor
antenna, radio wave reception
is weak. (Sound is distorted.)
■ AM
Problem
Too much noise during
broadcast.
The auto tuning function
(☞ P. 19) does not work.
Cause
The iPod is not supported by this unit.
Your iPod is properly connected to the
terminal of this unit, and the connection
between your iPod and this unit is
completed.
Your iPod was removed from the iPod
terminal of this unit.
This unit cannot play back songs
currently stored on your iPod.
Cause
The preset (memory) may have been
erased.
The power to this unit may have been
lost more than a week.
Cause
The FM antenna may be connected
improperly.
The radio station you selected may be
far from your area, or the radio wave
reception is weak in your area.
Multipath reflection or other radio
interferences may have occurred.
Cause
The noise may be caused by
atmospheric electricity, lightning,
fluorescent lights, motors, or
thermostat electric devices.
If this unit is placed near a TV, the
noise may be generated especially in
the evening.
The AM loop antenna may be
connected improperly.
Troubleshooting
Solution
Use iPod (Click and Wheel), iPod nano,
iPod mini, or iPod touch.
Connect your iPod to the iPod terminal of
this unit (☞ P. 13).
Check that the songs currently stored on
your iPod are playable.
Solution
Preset radio stations again (☞ P. 18).
Plug the power cable into the outlet
firmly, and preset the stations again
(☞ P. 6).
Solution
Make sure the FM antenna is connected
properly (☞ P. 17).
Try manual tuning to improve the signal
quality (☞ P. 18) or use a multi-channel
outdoor antenna.
Change the height, direction, or
placement of the antenna.
Solution
Connect an outdoor antenna and establish
a better grounding to decrease the noise.
However, it is difficult to eliminate these
types of noise.
Place this unit away from a TV.
Make sure the AM loop antenna is
connected properly (☞ P. 17).
27
En