Settings; Programming The Sound Bar With The Tv's Remote Control (Tv's Remote Control Learning Function) - Yamaha YAS-203 Mode D'emploi

Settings

Programming the sound bar with the TV's remote
control (TV's remote control learning function)
Once you program the sound bar, you can control it with your TV's remote control for
functions such as turning on/off the TV and sound bar simultaneously, or volume up/
down and muting/unmuting of the sound bar.
• This function is available only when your TV's remote control uses IR (infrared) signal.
• An RF (Radio Frequency) remote control will not work.
• If you want to use a cable or satellite set top box's remote control to operate the sound bar, use your
original TV's IR (infrared) remote control to program the sound bar, then use the set top box's remote
control to operate.
• If by changing the volume of the sound bar the TV's volume also changes, set the TV's volume to
minimum, or disable speaker output.
1
Turn off the TV.
2
Turn off the sound bar.
3
Hold down the LEARN key on the sound bar's remote control for
more than 3 seconds to set the sound bar to the learning mode.
When the sound bar is in the learning mode, the indicators on the front panel flash
as shown below.
NOTE
• Steps 4 to 7 require only the TV's remote control and the keys on the front panel of the sound bar.
The remote control of the sound bar is not necessary.
• If the sound bar has already learned functions, the following indicators light up.
Mute: BD/DVD, Volume (–): ANALOG, Volume (+): BLUETOOTH, Power: SURROUND
4
Teach the sound bar the "Mute" code of the TV's remote control.
4-1 Press MUTE on the front panel of the sound bar.
12
4-2 While pointing your TV's remote control at the remote control sensor, hold
down the mute key for more than 1 second twice or three times.
Approx. 30 cm (1 ft)
TV's remote control
Hold down Release
(more than 1 second) (more than 1 second)
Result Bleep/buzzer Indicators
Successfully
Once
learned
Failed to learn
* Repeat from Twice
Step 4-1.
5
Teach the sound bar the "Volume (–)" code of the TV's remote
control.
5-1 Press VOLUME (–) on the front panel of the sound bar.
5-2 While pointing your TV's remote control at the remote control sensor, hold
down the volume (–) key for more than 1 second twice or three times.
Result Bleep/buzzer Indicators
Successfully
Once
learned
Failed to learn
* Repeat from Twice
Step 5-1.
Hold down Release
(more than 1 second) (...)
Lights up
Flash
Lights up
Flash