Publicité
Les langues disponibles
Les langues disponibles
V1.1
4.
Continue to hold the button down and swing the nail guide cover
outward. Open the magazine cover (#92) open to reveal the nail
compartment (Fig. 3).
5.
To adjust the position of the nail
holder to correspond with the nail
length, turn the nail holder (#101)
about 90° counterclockwise.
6.
Move the nail holder (#101) up and
down to align the plate of the nail
holder with the mark on the
magazine (J) that corresponds with
the length of the nails being used
(see Specifications).
7.
Turn the nail holder 90° clockwise until you hear it click.
NOTICE! The nail will not feed smoothly if the nail holder is not correctly
adjusted.
8.
To place the nails in the magazine,
insert the first nail coil into the
magazine opening.
9.
Uncoil enough nails to reach the
driving hole.
10. Insert the first nail into the driving
hole and the second nail between
the two pawls of the feeder (#69).
11.
Fit the nail heads into the guide slot.
12. Pull the nails to the right (Fig. 4).
13. Close the magazine cover, then the nail guide. Push the latch button
downward until you can properly seat the nail guide. Release the latch
button and make sure the bolt is through the latch hole.
14. Reconnect the tool to the air supply.
15. Ensure the air pressure is within the correct range (see Specifications).
16. Test the tool on a sample workpiece to ensure desired performance
and results.
17.
Holding the handle (A) firmly, press the tool onto your workpiece in the
desired location and hold steady.
Visit www.princessauto.com for more information
Coil Roofing Air Nailer
8990889
Fig. 3
Fig. 4
9
Publicité
