Power Fist 8990889 Mode D'emploi page 10

8990889
18. Gently squeeze the trigger (C) to
drive the fastener into workpiece
(Fig. 5).
19. Release the trigger, lift the nailer
until the safety contact pin is no
longer touching the workpiece and
move to the next spot.
a. You can also choose to operate
in 'bump' mode. Do not release
the trigger when you lift the
nailer. Another fastener will fire each time you depress the safety
pin into the workpiece until you release the trigger.
20. Inspect workpiece.
a. If the fastener is driven too deep or too shallow into workpiece,
adjust the nailer's driving power before continuing.
b. If results are as desired, continue.
21. Release the trigger and lift the nailer away from the workpiece when
done.
22. When finished with the tool, turn off the air compressor, disconnect
the air hose and discharge any residual air remaining in the tool. Put
the impact wrench away in a safe storage area.
ADJUSTING THE NAILING DEPTH
It' s important to ensure that each fastener penetrates to the same depth
within the workpiece. This will help deliver consistent results.
Every 1/4 in. rotation of the adjuster changes the driving depth.
If the nails are driven too shallow, pull the adjuster downward and turn
counter-clockwise (Fig. 6).
If nails are driven too deep, pull the adjuster downward and turn clockwise
(Fig. 7).
10
Coil Roofing Air Nailer
Fig. 6
For technical questions call 1-800-665-8685
V1.1
Fig. 5
Fig. 7