Publicité
Les langues disponibles
Les langues disponibles
8990889
CLEAR JAMMED TOOL
NOTICE! Do not use the tool when a fastener has jammed in the firing mechanism.
the nailer
Firing
Remove any jammed fasteners before using the tool further.
To clear a jammed fastener, accomplish the following:
1.
Disconnect the tool from the air hose.
2.
Open the nail guide and insert a rod into the outlet.
3.
Tap the rod with hammer.
4.
Remove the jammed nail with a slotted screwdriver.
5.
Cut the deformed collated wire. Correct the deformation.
6.
Remove the non-jammed fasteners in the magazine.
7.
Operate the magazine latch and slide the pusher back to open the
magazine and check for jammed fasteners.
8.
Use pliers or any appropriate tool to remove the jammed fastener.
9.
Close the magazine cover and slide the pusher to its original position.
10. Reload the magazine.
11.
Reconnect the tool to the air hose.
12. Complete several test firings into a sample workpiece to ensure proper
operation.
WARNING! Disconnect the tool from the air supply before clearing jammed
fasteners.
MAINTENANCE SCHEDULE
Maintenance
Required
General inspection –
Free movement
In-depth inspection
Replace worn or
broken parts
Lubrication
12
Coil Roofing Air Nailer
while jammed can damage the mechanism and/or
Description
Trigger, spring,
safety mechanism
Worn or broken
parts
See below
Tools or Materials
Required
None
None
None
Pneumatic tool oil Each use or
For technical questions call 1-800-665-8685
V1.1
workpiece
.
Max. Service
Interval
Each use or
every 2 hours
Monthly
As needed
every 2 hours
Publicité
