When AirDry opens the door, the display
shows the remaining time of the running
programme.
CAUTION!
Do not try to close the appliance door
within 2 minutes after automatic opening.
This can cause damage to the appliance.
CAUTION!
If children have access to the appliance,
we advise to deactivate AirDry. The
automatic opening of the door may pose
a danger.
7.8 Key tones
The buttons on the control panel make a click
sound when you press them. You can
deactivate this sound.
7.9 TimeBeam
8. BEFORE FIRST USE
1. Adjust the level of the water softener
according to the hardness of the water
supply.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start Quick programme to remove any
residuals from the manufacturing
process. Do not use detergent and do not
put dishes in the baskets.
After starting the programme, the appliance
recharges the resin in the water softener for
up to 5 minutes. The washing phase starts
only after this procedure is complete. The
procedure is repeated periodically.
TimeBeam displays the following information
on the floor below the appliance door:
• The programme duration when the
programme begins.
• 0:00 and CLEAN when the programme is
completed.
• DELAY and the countdown duration when
the delay start begins.
• An alarm code when the appliance has a
malfunction.
When AirDry opens the door, TimeBeam
is off. To check the remaining time of the
running programme, look at the control
panel display.
8.1 The salt container
CAUTION!
Use only regeneration salt for
dishwashers. Do not use kitchen salt.
The salt is used to recharge the resin in the
water softener and to assure good washing
results in daily use.
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
ENGLISH
15