NEFF T1B22 Serie Manuel D'utilisation Et Notice D'installation page 39

Make a note of your appliance's details and the Cus-
tomer Service telephone number to find them again
quickly.
14 Installation instructions
I n s t a l l a t i o n i n s t r u c t i o n s
Observe this information when installing the appliance.
14.1 Safe installation
Follow these safety instructions when in-
stalling the appliance.
¡ Electrical connection must only be carried
out by licensed specialist staff. Incorrect
connection will invalidate the warranty.
¡ The safe operation of this appliance can
only be guaranteed if it has been installed
to a professional standard in accordance
with these installation instructions. The in-
staller shall be liable for any damage result-
ing from incorrect installation.
14.4 Preparing the units
The worktop must be level, horizontal and stable.
¡ The fitted units, including wall finishing strips, must
be heat-resistant to at least 90 °C.
¡ Niche cladding within 50 mm of the back wall must
not be combustible (e.g. tiles, stone).
14.5 Electrical connection
To protect the device, only remove the device from the
styrofoam shells when you press the device into the
cut-out. Never place the device upright on one side of
the device.
¡ Check the household wiring before connecting the
appliance.
14.2 Built-under
Do not install refrigerators, dishwashers, non-ventilated
ovens or washing machines underneath the appliance.
¡ If you fit an oven below the appliance, the worktop
must be at least 20 mm thick, in certain cases even
thicker. Observe the information in the oven installa-
tion instructions.
¡ Make sure that projecting parts such as the mains
housing or the mains cable do not collide, e.g. with
a drawer.
14.3 Intermediate floor
If the underside of the hob can be touched, an interme-
diate floor must be fitted.
¡ Ask your specialist retailer for an intermediate floor
as an accessory.
¡ If you use your own intermediate floor, the minimum
distance to the mains connection of the appliance
must be 10 mm.
¡ Seal the cut surfaces to make them heat-resistant.
This prevents the worktop from swelling as a result
of moisture.
¡ The appliance fulfils the requirements of protection
class I and must only be operated in conjunction
with an earth conductor.
¡ In the permanent electrical installation, a partition
must be provided in the phases in accordance with
the installation regulations.
Installation instructions en
39