Rowenta DR81 Serie Mode D'emploi page 29

IS THERE A PROBLEM ?
PROBLEMS
There is no steam.
The appliance does
not heat.
Water leaks.
Steam rate
decreases.
The steam leaves
stains on the fabric
or the appliance
spits.
Appliance steams
continuously.
The powercord is
difficult to rewind
POSSIBLE CAUSES
The appliance is not plugged in, or
not switched on.
The water level is too low.
The steam pump has not been
primed.
You are using the appliance for the
first time.
The water tank is not fully in place.
The appliance is on standby mode.
It is not plugged in, or not switched
on.
The appliance is on standby mode.
The water tank is not fully in
place or the stopper is not closed
properly.
Calc Sealing.
You are using water with additives.
The appliance has not been
cleaned enough after the descaling
operation.
You are using other liquids than
white vinegar to descale the
product.
The steam trigger is on the lock
position.
The powercord is twisted
SOLUTIONS
Check that your appliance
is correctly plugged in and
switched on.
Unplug your appliance and refill it.
Press the steam trigger
continuously for a few
seconds to begin steaming.
Press the steam trigger
continuously for a few
seconds to begin steaming.
Ensure that stopper is closed and
that the water tank snaps when put
into place.
PLEASE REFER TO THE 'STANDBY
MODE' section.
Plug in your appliance and switch
on.
PLEASE REFER TO THE 'STANDBY
MODE' section.
Ensure that stopper is closed and
that the water tank snaps when put
into place.
Refer to 'EASY DESCALING' section
in instructions for use.
Never add any additive in the water
tank.
Read carefully the
'EASY DESCALING' section
in instructions for use.
Use only white vinegar during
'EASY DESCALING' procedure.
Unlock the steam trigger.
Gently pull out the powercord and
rewind again while guiding until it
is completely rolled.
29