NEFF T16BT6 Serie Manuel D'utilisation Et Notice D'installation page 46

en Installation instructions
Use a suitable silicone adhesive to fill the gap
4.
between the work surface and the ceramic plate.
Before a skin forms on the silicone adhesive,
smooth it with a scraper, or your finger, wetted with
soapy water.
Notes
¡ Do not use the appliance until the silicone adhesive
has cured.
¡ If you use an unsuitable silicone adhesive on natural
stone work surfaces, it may cause discolouration. A
suitable adhesive can be obtained from our cus-
tomer service.
18.7 Removing the hob
Disconnect the appliance from the power supply.
1.
Cut the seal around the ceramic plate.
2.
Push out the hob from below.
3.
46