NEFF T16BT6 Serie Manuel D'utilisation Et Notice D'installation page 45

¡ Make sure that projecting parts such as the mains
housing or the mains cable do not collide, e.g. with
a drawer.
18.3 Intermediate floor
If the underside of the hob can be touched, an interme-
diate floor must be fitted.
18.4 Preparing the units
The worktop must be level, horizontal and stable.
¡ Have the worktop cut-out made in a specialist work-
shop only.
¡ Use only water-resistant work surfaces (e.g. natural
stone).
18.5 Electrical connection
To protect the device, only remove the device from the
styrofoam shells when you press the device into the
cut-out. Never place the device upright on one side of
the device.
¡ Check the household wiring before connecting the
appliance.
¡ The appliance fulfils the requirements of protection
class I and must only be operated in conjunction
with an earth conductor.
¡ In the permanent electrical installation, a partition
must be provided in the phases in accordance with
the installation regulations.
¡ If appears on the appliance's display, it has
not been connected correctly. Disconnect the appli-
ance from the mains and check the connection.
Connecting without a pre-installed cable
Only connect the hob in accordance with the connec-
tion diagram.
¡ If required, install the enclosed copper bridges.
¡ The power cable must correspond to type H05 VV-F
or a higher rating.
¡ Use the current load to determine which wire cross-
section you require. A cross-section of < 1.5 mm² is
not permitted.
¡ Ask your specialist retailer for an intermediate floor
as an accessory.
¡ If you use your own intermediate floor, the minimum
distance to the mains connection of the appliance
must be 10 mm.
¡ The fitted units, including wall finishing strips, must
be heat-resistant to at least 90 °C.
¡ Niche cladding within 50 mm of the back wall must
not be combustible (e.g. tiles, stone).
18.6 Installing the hob
Ensure that the cables are not trapped or pinched, and
do not route them over sharp edges. If the oven is a
built-under type, route the cable along the rear corners
of the oven to the mains socket.
Bond the supplied seal in place.
1.
Install and align the hob so that it is horizontal.
2.
Check that the appliance works correctly.
3.
Installation instructions en
45