Philips WelcomeEye Comfort Pro Mode D'emploi page 31

4. Installing the main or additional intercom panel
Warning: The product must not be connected to the power supply before wiring is complete.
1
4
5 3 1 0 2 3
1 2
1 2
1 2 3 4 5 6 7 8
1 2
SMARTHOME FRANCE 5 3 1 0 2 3
19 avenue Marcel Dassault 37200 TOURS
FRANCE
20V 110mA
RFID 125kHz
IP44
7
1 - Remove the tamper-resistant screw from the intercom panel.
2 - Tip the intercom panel cover forward.
3 – The intercom's lens should be approximately 1.60m above the ground.
4 – Mark the locations.
5 - Drill.
6 - Use the correct fixings for the mounting surface (the screws provided are suitable for
solid walls).
7 – Connect the two wires from the monitor and, if necessary, connect the electric strike
plate and the gate (see section 1. Wiring). Configure the switches at the back of the
intercom panel (see section 2. Configuring the intercom).
8 – Insert the screws and refit the two caps concealing the retaining screws.
Note: the screws must be driven through the black grommets on the back of the outdoor
station.
2
5
2 1
1
2
8
WelcomeEye Comfort Pro / V5
1m60
3
6
9
GB8