AEG IKE96654FB Notice D'utilisation page 117

Auto‐
matic
light
Mode H6 On
1)
The hob detects the boiling process and activates
the fan speed in accordance with the automatic mode.
2)
The hob detects the frying process and activates the
fan speed in accordance with the automatic mode.
3)
This mode activates the fan and the light and does
not rely on the temperature.
Changing the automatic mode
1. Deactivate the appliance.
2. Touch for 3 seconds.
The display comes on and goes off.
3. Touch for 3 seconds.
4. Touch a few times until
5. Touch of the Timer to select an
automatic mode.
When you finish cooking and deactivate the
hob, the hood fan may still operate for a
certain period of time. After that time the
system deactivates the fan automatically and
prevents you from an accidental activation of
the fan for the next 30 seconds.
To operate the hood directly on the hood
panel deactivate the automatic mode of
the function.
Operating the fan speed manually
You can also operate the fan from the hob
manually.
Touch when the hob is active.
This deactivates automatic operation of the
function and allows you to change the fan
speed manually.
When you press , you raise the fan speed
by one. When you reach an intensive level
Boiling 1) Frying 2)
Fan speed Fan speed
2 3
comes on.
and press again, you set the fan speed to
0 which deactivates the hood fan. To start the
fan again with the fan speed 1 touch
To activate an automatic operation of the
function, deactivate the hob and activate
it again.
5.15 Power management
If multiple zones are active and the
consumed power exceeds the limitation of the
power supply, this function divides the
available power between all cooking zones
(connected to the same phase). The hob
controls heat settings to protect the fuses of
the house installation.
• Cooking zones are grouped according to
the location and number of the phases in
the hob. Each phase has a maximum
electricity loading of 3680 W. If the hob
reaches the limit of maximum available
power within one phase, the power of the
cooking zones will be automatically
reduced.
• For cooking zones that have a reduced
power, the control panel shows the
maximum possible heat settings.
• If a higher heat setting is not available
reduce it for the other cooking zones first.
• The activation of the function depends on
the number and size of pots.
Refer to the illustration for possible
combinations in which power can be
distributed among the cooking zones.
.
ENGLISH 117