Publicité
Les langues disponibles
Les langues disponibles
Until the front fairing is repositioned correctly and the pin
is inserted into the base, the machine will not turn on and
will not be operational. This avoids exposing the operator
to any risk of traction trapping by the rollers.
PASADO
PASADOR
DO
D
D O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
O
R
R
R
R
R
R
R
R
R
R
R
R
R
R
BASE
BASE
Maintenance
Cleaning
Correct maintenance of the equipment is essential for a good result. Follow the following disassembly and cleaning steps
shown below.
1
Press the red OFF button on the control panel and
disconnect the equipment from the power supply.
IMPORTANT: The equipment must be stopped and
disconnected before handling it in any way.
3
Using a Nº. 4 Allen key unscrew the 4 head bolts, as
shown in the image (1). Next, remove the head, as
shown in the image (2) and clean it.
Image (1)
24
g
y
y
Image (2)
IMPORTANT: Always remember to correctly fix the front
fairing of the machine by tightening the four side knobs
as shown in the following images.
2
Remove the exit ramp (B) by lifting it vertically.
Image (1)
4
Loosen the 2 side knobs as shown in the image (1). Do
the same with the 2 knobs on the opposite side, as
shown in the image (2). IMPORTANT: The equipment
must be stopped and disconnected before handling
it in any way.
Image (1)
Image (2)
Image (2)
Publicité
