Publicité
Les langues disponibles
Les langues disponibles
Basic safety instructions
Safety symbols
HAZARD
This symbol means that there is a possible imminent danger to the physical integrity and life of people.
Failure to observe these indications can lead to serious harmful effects caused by possible life-threate-
ning injuries.
WARNING
This symbol means that there is a possible imminent danger to the physical integrity and life of people.
Failure to observe these instructions can lead to damage to the machine and the user.
INFORMATION
Under these symbols, you will find particularly practical advice and information. The symbol marks
important instructions for proper handling of the machine. Failure to observe these instructions may
lead to misuse of the article in question.
User safety
+
The flowers to be processed by this equipment should only be fresh and/or dry, either herbaceous and/or semi-woody.
Processing of any plant of a different nature can cause injury to the user and the equipment.
+
Always use the equipment with gloves and safety glasses. While the equipment is operating, fragments of plants can
detach and fly out at high speed, causing a possible collision with the eyes.
+
Never come near the operating equipment wearing loose clothing as there is a possible risk of being caught and trapped.
Only use the equipment if it is in perfect condition, otherwise there may be risks for users.
+
+
Safety devices such as switches and protections must not be dismantled under any circumstances.
+
Make sure that the MB Bucker 200 is properly closed and the buttons are off before performing any maintenance on it.
+
Do not bring your hands, or any other object that could damage it or the operator, close to the inlet head of the equipment.
Who can use the MB Bucker 200
Master Products machines must only be used by users who have read and understood this manual.
How to stop the MB Bucker 200
Master Products machines are turned off under all circumstances whenever the OFF (coloured red) switches are pressed.
Before carrying out any maintenance action on the machine, it must be disconnected from the mains. The unit must be swit-
ched off and disconnected from the electrical current immediately in case of abnormal operation.
MB Bucker 200 Repair
Only qualified staff can dismantle, repair and install new parts. If the product is within its warranty period, only a Master
Products engineer is allowed to make any changes without voiding the warranty.
Disclaimers
Modifications to Master Products equipment are prohibited without manufacturer approval. Following unauthorised modi-
fication, the manufacturer declines any responsibility and cancels the warranty rights for the machines to which modifica-
tions have been made. The manufacturer will not be responsible for any failures and accidents that may result.
During the warranty period, Master Products equipment may only be disassembled and repaired by the manufacturer's
technical staff or its official representatives.
The operator who uses the machine must ensure that the crushed material is removed regularly, since the residues can
cause an obstruction and, therefore, a malfunction of the machine.
17
Publicité
