Master MB Bucker 200 Manuel D'utilisation Et De Maintenance page 18

Transport
Electrical connection
The MB Bucker 200 machine should be connected to a single-phase 230 V/50-60 Hz
Placement
The MB Bucker 200 must be placed on a raised and flat surface, ensuring its stability and a good working position for the
user. It is only suitable for indoor use and under no circumstances should the electrical part be exposed to water.
Start-up
Assembling the machine
1
The MB Bucker 200 is delivered fully protected and boxed. Open the box and remove the upper expanded polystyrene
cover. Remove the machine and the outlet ramp (B) that is found separately inside the box.
2
Place the MB Bucker 200 on a flat and stable surface. Fit the exit ramp (B) into the slots of the front fairing, as
shown in the image. The equipment is shipped in hibernation mode so that it arrives in optimal condition. The
next section explains how to prepare the machine for use.
18
Box 50x58x66cm = 45 kg / / MB Bucker 200 net weight = 40 kg
electrical power supply.