ecofort ecoQ DryAir 20L Essential Manuel D'utilisation page 77

Humidity Setting
Adjust Button
In Hygrostat and Sleep modes the target humidity can be set as to when
the device automatically stops dehumidifying as soon as the desired target
humidity is reached.
The target humidity can be set in 5% increments: 30-35-40-45-50-55-60-65-
70-75-80%
Use this button to set the number of hours for the Timer function (see below).
Press and hold this button to display the ambient temperature. After a few
seconds, the display jumps back to the ambient relative humidity.
Fan Speed
Press to switch between Low and High Fan Speed. The corresponding indicator
will be shown on the display.
Note: During defrosting the Fan Speed cannot be changed.
Timer
The timer function can be used as a switch-on or switch-off timer. If the device
is in Off status, set the interval after how many hours the device should switch
on. If the device is in On status, set the interval after how many hours the
device should switch off.
First press the Timer button; with each press of the Adjust Button, the value
is increased by one hour from 00 to 24 hours. With the setting 00, the Timer
function is cancelled. The Timer function can also be cancelled by turning the
device Off and then On again.
When the timer is active, the corresponding indicator is displayed.
Child Lock
To prevent the mishandling by young children, the unit is equipped with a Child
Lock function, which will make all buttons on the unit non-functional. Press
this button for 3 seconds to activate or deactivate the child lock function.
After activating the child lock function, the child lock indicator will be displayed
on screen.
Instruction Manual ecoQ DryAir 20L Essential | 75