Garmin Force Kraken Manuel De Demarrage Rapide page 9

3 On the remote control, select > Settings > Trolling Motor > Calibrate >
Compass.
4 Using the foot pedal or outboard motor to steer, follow the on-screen
instructions.
Calibrating the Remote Control
NOTICE
Calibrate the electronic compass outdoors. To improve heading accuracy,
do not stand near objects that influence magnetic fields, such as vehicles,
buildings, and overhead power lines.
You must calibrate the compass in the remote control before you can control
the motor using gestures. If the gesture controls are not working properly after
calibration, you can repeat this process as often as needed.
1 Select > Settings > Remote Control > Calibrate.
2 Select Start, and follow the on-screen instructions.
Gain Settings
If the autopilot features, such as heading hold and anchor lock, do not perform
as expected, you may need to adjust the gain settings.
See the online owner's manual for more information (page 10).
Connecting to a Chartplotter
Your compatible Garmin chartplotter must have the latest software version
installed before you can connect the trolling motor.
You can connect the trolling motor wirelessly to a compatible Garmin
chartplotter on your boat. After you connect to a compatible chartplotter, you
can control the trolling motor from the chartplotter in addition to the remote
control and foot pedal.
1 Turn on the chartplotter and the trolling motor.
2 Make sure that the chartplotter is hosting a wireless network.
NOTE: If you have multiple chartplotters installed, only one is the
wireless network host. Consult your chartplotter's owner's manual for more
information.
Quick Start Manual
3 On the chartplotter, select Settings > Communications > Wireless Devices >
Garmin Trolling Motor > Start.
4 On the trolling motor display panel, press
mode.
on the trolling motor display panel illuminates blue as it searches for a
connection to the chartplotter, and changes to green when the connection is
successful.
A confirmation message appears on the chartplotter when the connection is
successful.
5 After the chartplotter and trolling motor connect successfully, enable the
trolling motor bar on the chartplotter to control the motor.
See the latest version of your chartplotter's owner's manual for complete
operation instructions.
Pairing the Remote Control
The remote control is paired with the trolling motor at the factory, but you may
need to pair them again if the connection is broken.
1 Turn on the trolling motor.
2 On the trolling motor display panel, press
mode.
on the trolling motor display panel illuminates blue as it searches for a
connection.
3 Bring the remote control within 1 m (3 ft.) of the display panel on the trolling
motor.
4 Turn on the remote control.
5 On the remote control, select > Settings > Remote Control > Pair > Start.
on the trolling motor display panel illuminates green when the connection
is successful.
Pairing the Foot Pedal
The foot pedal is paired with the trolling motor at the factory, but you may need
to pair them again if the connection is broken.
three times to enter pairing
three times to enter pairing
9