MINN KOTA RAPTOR Manuel D'instructions page 8

INSTALLING THE FOOT SWITCH
3
ITEM(S) NEEDED
#2 x 3
c. Double check the Mounting Location. Take the Screws
(Item #2) and place one each in the Mounting Holes
of the Pedestal. Make sure the Mounting Holes line up
with the Marked Locations and then use a Drill with #2
Phillips Driving Bit to secure the Pedestal to the Deck
of the Boat. Do not over-tighten.
4
d. Once the Pedestal is installed, take the Foot Switch
and reattach it to the Pedestal. Make sure the Tabs on
the Foot Switch click into place and the Foot Switch is
fully seated on the Deck of the Boat.
8 | minnkota.johnsonoutdoors.com
Screws Screws
Deck of Boat Deck of Boat
Foot Foot
Switch Switch
Tab Tab
Deck of Boat Deck of Boat
Pedestal Pedestal
Mounting Holes Mounting Holes
Tab Tab
Pedestal Pedestal
©2024 Johnson Outdoors Marine Electronics, Inc.