MINN KOTA RAPTOR Manuel D'instructions page 13

Toggle the Anchor Mode from the Foot Switch
Toggle the Anchor Mode on the Foot Switch when the water or anchoring conditions change to fit your anchoring needs.
1
a. Single press the Anchor Mode
the current Mode.
b. While the Mode is displayed via the Mode LED,
continue to single press through the Modes to toggle
between Standard, Rough Water, Soft Water and Auto
Bottom. Standard Mode is identified when the Mode
LED
Rough Water mode is identified when the Mode LED
flashes red and Soft Bottom when the Mode LED
flashes green. Auto Bottom Mode is only available
on the Active Anchoring Model and is identified by a
Mode LED
to green and then red to red.
Toggle Active Anchoring
Active Anchoring is a feature that comes preinstalled on select Raptor models. To learn more about Active Anchoring, see the "Using the
Raptor" section of the Raptor Owner's Manual.
1
a. Active Anchoring is engaged and disengaged by a
single press and hold the Anchor Mode
When the Mode LED
and then one longer flash of green it is enabled and
when the Mode LED
and then one longer flash of red it is disabled.
©2024 Johnson Outdoors Marine Electronics, Inc.
button to display
flashes between red and green.
that flashes slowly from green
button.
displays three short flashes
displays three short flashes
USING THE FOOT SWITCH
Anchor
Mode Button
Raptor Foot Switch
When the Raptor is paired with a second Raptor,
NOTICE:
changing the Anchor Mode on one Raptor will change
the Mode for both Raptors. Read the "Using the Raptor"
section of the Raptor Owner's Manual to learn more
about Modes.
Raptor Foot Switch
Anchor Mode
Selection LED
Anchor Mode Button
minnkota.johnsonoutdoors.com | 13