MINN KOTA RAPTOR Manuel D'instructions page 12

USING THE FOOT SWITCH
Retracting the Raptor from the Foot Switch
Use the buttons on the Foot Switch to retract the Raptor anchor.
1
a. To auto retract the Raptor, press and then release
the Up button on the Foot Switch. To continually
retract the Raptor, press and hold the Up
b. While auto retracting, the action can be paused
by either pressing the Up
pressing the Down
continually retracting, the action can be paused on the
Foot Switch by releasing the Up
c. The paused retraction can be resumed by pressing
the Up button again in the same manner.
d. If auto retracting, the anchor will stop when the
anchor is fully retracted. If continually retracting
the button should be released when the anchor is
fully retracted.
Be sure that the Raptor is clear of obstructions and persons while deploying or retracting. Take care that neither you nor other persons
approach the Raptor too closely, while operating, neither with body parts nor with objects. The Raptor is powerful and may endanger
or injure you or others. While the Raptor is operating, watch out for persons swimming and for floating objects. Persons who lack the
ability to run the Raptor or whose reactions are impaired by alcohol, drugs, medication, or other substances are not permitted to use
this product.
The spaces between the Outer Arm, Inner Arm, Spike and brackets of the Raptor can create a pinch point. Do not come in contact with an
area of the Raptor that may cause a pinch point while it is moving in any direction to avoid the risk.
12 | minnkota.johnsonoutdoors.com
button.
button again, or by
button. While the anchor is
button.
WARNING
CAUTION
Auto Up Button/
Pairing Button
Raptor Foot Switch
When two Raptors are paired, the Raptor
NOTICE:
selected on the Foot Switch will retract. The selection can
be Port, Starboard, or both.
Auto Down
Button/Pairing
Button
©2024 Johnson Outdoors Marine Electronics, Inc.