MINN KOTA RAPTOR Manuel D'instructions page 7

INSTALLATION
Installing the Foot Switch
1
ITEM(S) NEEDED
a. Review the Mounting Considerations to determine
an acceptable mounting location. Once a location
is selected, take the Raptor Foot Switch Assembly
(Item #A) and remove the Pedestal from the Base by
squeezing the Tabs on both sides of the Foot Pedal
and pulling the Foot Switch and Pedestal apart.
The Pedestal comes attached to the Foot
NOTICE:
Switch and needs to be removed for installation.
2
b. The Pedestal has three Mounting Holes that are
used to secure it to the boat. The bottom side of the
Pedestal has three Pads around the Mounting Holes.
These Pads should be placed down, towards the boat
when the Pedestal is installed. Position the Pedestal
at the selected location and mark the Mounting Holes
with a pencil or similar marking tool.
©2024 Johnson Outdoors Marine Electronics, Inc.
#A x 1
INSTALLING THE FOOT SWITCH
Foot Switch Foot Switch
Tab Tab
Pedestal Pedestal
Pedestal (top) Pedestal (top)
Pedestal (bottom) Pedestal (bottom)
Tab Tab
Marked Location Marked Location
Mounting Holes Mounting Holes
Pads Pads
minnkota.johnsonoutdoors.com | 7