MINN KOTA RAPTOR Manuel D'instructions page 6

INSTALLING THE RAPTOR FOOT SWITCH
Your new Raptor Foot Switch comes complete with all of the hardware you'll need to install it directly to the deck of your boat. Please
review the parts list, mounting considerations and tools needed for installation prior to getting started.
INSTALLATION PARTS LIST
Item /
Part # Description
Assembly
A 2994155 FOOT SWITCH ASM, RAPTOR
2 2383455 SCREW-#8 X 1.0" PPH TY AB SS
s
2357153 QCK REF GUIDE, FT SWITCH
s
2357152 MANUAL, FT SWITCH, RAPTOR
✖
This part is included in an assembly and cannot be ordered individually.
s
Not shown on Parts Diagram.
MOUNTING CONSIDERATIONS
Before mounting your Raptor Foot Switch, please give consideration to the following:
1. Examine your boat to ensure that you will not drill into any obstructions and that the hardware will be accessible for assembly.
2. Make sure the area under the mounting location is flat, clear to drill holes and that the installation hardware will not damage existing
components below the mounting surface. It may be necessary to shim or modify the mounting surface under the mounting location
to create a flat area for the Foot Switch Pedestal to be mounted.
3. Mount the Raptor Foot Switch in an area that has a clear line of communication with the Raptor(s) it is intended to control for
optimum performance.
4. Mount the Raptor Foot Switch in an area where it will not become a tripping hazard.
TOOLS AND RESOURCES REQUIRED
• Pencil or similar marking tool
• Drill
6 | minnkota.johnsonoutdoors.com
INSTALLATION
Qty.
1
3
1
1
• #2 Phillips Driving Bit
A
©2024 Johnson Outdoors Marine Electronics, Inc.
2