MINN KOTA RAPTOR Manuel D'instructions page 10

USING THE FOOT SWITCH
CONTROLLING THE RAPTOR WITH THE FOOT SWITCH
Auto Up Button/
Pairing Button
Auto Up Button
Single press to auto retract the anchor. Press and hold to continually retract the anchor. The anchor will continue to retract when the
button is held until the button is released. Also used to pair the Foot Switch to a Raptor.
Auto Down Button
Double press to auto deploy the anchor. Double press and hold the second press to continually deploy the anchor. The anchor will
continue to deploy when the button is held until it reaches its full range of operation or until the button is released. Also used to
pair the Foot Switch to a Raptor.
Anchor Mode Button
Single press to display the current Anchor Mode. While the mode is displayed, continue to single press through the Anchor Modes
to change them. This will toggle through the Anchor Modes of Standard, Rough Water, Soft Bottom and Auto Bottom. Standard
Mode is identified when the Mode LED
Mode LED flashes red and Soft Bottom when the Mode LED
Anchoring Model and is identified by a Mode LED
Active Anchoring Model, the Anchor Mode button will also enable and disable Active Anchoring. Active Anchoring is engaged and
disengaged by a single press and hold. When the Mode LED
it is disabled.
Speed Button / Anchor Selection Button
Single press to display the current operating speed. While the speed is displayed, continue to single press through the operating
speed to toggle between slow, medium and fast. The Mode LED
corresponds with the selected speed. Pressing and holding the button will toggle the Foot Switch to control either the Port,
Starboard or both anchors (when two anchors are paired in the system). The Raptor Selection LEDs
correspond to the anchor(s) selected. The right LED
will illuminate when the Port anchor is selected. Both the right and left LEDs
10 | minnkota.johnsonoutdoors.com
Anchor Mode
Selection LED
Anchor
Mode Button
Raptor Selection Indicator LEDs
flashes between red and green. Rough Water mode is identified when the
flashes green. Auto Bottom Mode is only available on the Active
that flashes slowly from green to green and then red to red. On the
displays green it is enabled and when the Mode LED
will flash red three consecutive times at the speed that
will illuminate when the Starboard anchor is selected and the left LED
Raptor Selection Button/
Speed Button
Auto Down
Button/Pairing
Button
will illuminate to
illuminate when both anchors are selected.
©2024 Johnson Outdoors Marine Electronics, Inc.
displays red