Deploy the Raptor from the Foot Switch
Use the buttons on the Foot Switch to deploy the Raptor anchor.
1
a.
To auto deploy the Raptor, double press and then
release the Down
continually deploy the Raptor, double press the Down
button and hold the second press.
b.
While auto deploying, the action can be paused by
pressing the Down
is continually deploying, the action can be paused on
the Foot Switch by releasing the Down
c.
The paused deployment can be resumed by pressing
the Down
d.
If continuing to deploy the Raptor, and the anchor gets
to its full length of travel, it will stop. If auto deploying
the anchor, once the deploying anchor gets to its full
length of travel or comes in contact with the bottom, it
will go through an anchoring sequence determined by
the current Mode and then stop.
Be sure that the Raptor is clear of obstructions and persons while deploying or retracting. Take care that neither you nor other persons
approach the Raptor too closely while operating, neither with body parts nor with objects. The Raptor is powerful and may endanger
or injure you or others. While the Raptor is operating, watch out for persons swimming and for floating objects. Persons who lack the
ability to run the Raptor or whose reactions are impaired by alcohol, drugs, medication, or other substances are not permitted to use
this product.
The spaces between the Outer Arm, Inner Arm, Spike and brackets of the Raptor can create a pinch point. Do not come in contact with an
area of the Raptor that may cause a pinch point while it is moving in any direction to avoid the risk.
©2024 Johnson Outdoors Marine Electronics, Inc.
button on the Foot Switch. To
button again. While the anchor
Button.
button again in the same manner.
WARNING
CAUTION
USING THE FOOT SWITCH
Auto Up Button/
Pairing Button
Raptor Foot Switch
When two Raptors are paired, the selected
NOTICE:
Raptor will deploy. The selection can be Port, Starboard,
or both.
Auto Down
Button/Pairing
Button
minnkota.johnsonoutdoors.com | 11