Publicité
Les langues disponibles
Les langues disponibles
•
A damaged or incorrect guard can cause injury. Do
not use a cutting attachment that does not have an
approved guard attached.
•
The drive disc and support flange must engage
correctly in the centre hole of the cutting attachment.
A cutting attachment that is attached incorrectly can
cause injury or death.
•
To operate the product safely and prevent injury
to the operator or other persons, the product must
always be attached correctly to the harness.
Safety instructions for maintenance
WARNING:
instructions that follow before you do
maintenance on the product.
•
Remove the battery before you do maintenance,
other checks or assemble the product.
•
The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
To assemble the handlebar
1. Remove the screw behind the throttle handle. (Fig.
31)
2. Move the throttle handle to the right side of the
handlebar.
3. Align the hole behind the throttle handle with the
hole in the handlebar.
4. Put the screw go through the holes. Tighten the
screw.
5. Attach the handlebar between the arrows on the
shaft. Tighten the screw. (Fig. 32)
To put the handlebar in transport
position
1. Loosen the knob.
2. Turn the handlebar until it is parallel to the shaft.
(Fig. 33)
3. Turn the handlebar around the shaft until the
handlebar clamp locks into transport position. (Fig.
34)
4. Tighten the knob.
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING:
remove the battery. Use protective gloves.
16
Read the warning
Assembly
Stop the product and
•
Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
•
If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
•
Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
•
Keep the teeth of the blade correctly sharpened.
Obey our recommendations. Also refer to the
instructions on the blade package.
•
Only use original spare parts.
•
Always use heavy duty gloves when you repair the
cutting attachment. The blades are very sharp and
can easily cause injuries.
WARNING:
attachment guard that is recommended for
the cutting attachment. See
page 23 .
WARNING:
cutting attachment can result in injury or
death.
Cutting equipment and guards
The product uses the same cutting attachment guard for
the grass blade and the trimmer head.
•
Cutting attachment guard and grass blade.
(Fig. 35)
•
Cutting attachment guard and trimmer head.
(Fig. 36)
Assembly of the trimmer head, the
cutting attachment guard and the grass
blade
To attach the trimmer head T35
1. Put the drive disc (B) on the output shaft.
2. Turn the output shaft to align one of the holes in the
drive disc with the related hole in the gear housing.
3. Put the locking pin (C) in the hole to lock the shaft.
4. Turn the trimmer head (H) counterclockwise to
attach. (Fig. 37)
Always use the cutting
Accessories on
An incorrectly attached
1859 - 006 - 21.05.2024
Publicité
