Publicité
Les langues disponibles
Les langues disponibles
To do a check of the cutting attachment guard
WARNING:
attachment without an approved and
correctly attached cutting attachment guard.
Always use the recommended cutting
attachment guard for the cutting attachment
that you use, see
If an incorrect or faulty cutting attachment
guard is attached this can cause serious
personal injury.
The cutting attachment guard stops objects that ejects in
the direction of the operator. It also prevents injuries that
occur if you touch the cutting attachment.
1. Stop the product and remove the battery.
2. Do a visual check for damages, for example cracks.
(Fig. 28)
3. Replace the cutting attachment guard if it is
damaged.
To attach and remove the locknut
WARNING:
remove the battery, use protective gloves
and be careful around the sharp edges of
the cutting attachment.
A locknut is used to attach some types of cutting
attachments. The locknut has a left thread.
(Fig. 29)
•
To attach, tighten the locknut in the opposite
direction to the direction of rotation of the cutting
attachment.
•
To remove the locknut, undo the lock nut in the
same direction as the cutting attachment rotates.
•
To loose and tighten the locknut, use a socket
spanner with a long shaft. The arrow in the picture
shows the area where you should operate the socket
spanner.
Note:
Make sure that you can not turn the locknut by
hand. Replace the nut if the nylon lining does not have
a resistance of a minimum of 1.5 Nm. The nut should
be replaced after it has been put on approximately 10
times.
Cutting attachment
WARNING:
make sure that the cutting attachment stops
completely before you work on any part of
the cutting attachment.
WARNING:
attachment. Only use the cutting attachment
with the guards we recommend, refer
1859 - 006 - 21.05.2024
Do not use a cutting
Accessories on page 23 .
Stop the product and
Remove the battery and
Use correct cutting
Accessories on page 23 . Make sure
to
that the cutting attachment is sharpened
correctly. A cutting attachment that is not
sharpened correctly increases the risk of
blade thrust.
WARNING:
cause injury while it continues to spin after
the switch has been released. Need to
maintain proper control until the blade has
completely stopped rotating.
(Fig. 30)
Wear protective gloves when the cutting attachment is
handled.
•
Use the blades and grass knives to cut coarse grass.
•
Use the trimmer head to trim grass.
•
Check the cutting attachment for damage or cracks.
Replace a damaged cutting attachment.
Trimmer head
•
Always use the correct trimmer head, cutting
attachments and always use the recommended
trimmer line. Refer to
the assembly in the end of the Manual.
•
Make sure that the cutter on the trimmer guard is not
damaged.
•
Make sure that the trimmer line is wound tightly
and equally around the drum to prevent unusual
vibrations from the product. Different cord lengths
can result in vibrations that are not necessary. Tap
the trimmer head to get correct length on the cord.
To increase the life of the cord it can be soaked in water
for 2 days or more before assembly. This will make the
cord more resistant.
Grass blade
•
Use correctly sharpened blades. An incorrectly
sharpened or damaged blade increases the risk of
injury.
•
To sharpen and set the blade correctly, refer to the
instructions that come with the blade.
Safety instructions for assembly
WARNING:
obey these instructions carefully before you
use the product.
•
Remove the battery from the product before you
assemble the product.
•
Use approved protective gloves.
•
When you use a grass blade, make sure that the
correct blade guard and the harness are attached to
the product.
A coasting blade can
Accessories on page 23 and
Read, understand and
15
Publicité
