R&G LP0308BK Notice De Montage page 7

Page 14 of 21
Maintenant, le panneau latéral droit arrière peut être refixé en serrant d'abord les boulons
•
illustrés sur la photo 2, puis en serrant les vis illustrées sur la photo 1.
Le siège peut ensuite être remis en place, en s'assurant qu'il s'enclenche et qu'il soit sécurisé
•
par le mécanisme de verrouillage.
La bonde en caoutchouc fournie (article 6) peut être utilisée pour couvrir la serrure à clé du
•
siège et la protéger de la saleté et de l'eau. Poussez-le sur le barillet de la serrure et il restera
en place. Notez que la serrure à clé peut être actionnée avec le bouchon en caoutchouc en
place.
IMPORTANT: SI VOUS INSTALLEZ UNE PLAQUE D'IMMATRICULATION DE GRANDE
TAILLE ET LA PLACEZ LOIN VERS LE BAS SUR LE SUPPORT DE PLAQUE
D'IMMATRICULATION, IL Y A UNE FAIBLE CHANCE QUE LA PLAQUE
D'IMMATRICULATION FRAPPE LA ROUE ARRIÈRE SOUS L'EFFET D'UNE CHARGE
LOURDE ET SUR DE GRANDES BOSSES SUR LA ROUTE. IL EST DE VOTRE
RESPONSABILITÉ DE VÉRIFIER CETTE POSSIBILITÉ ET DE PRENDRE DES MESURES
POUR L'ÉVITER. NE PAS VÉRIFIER CECI POURRAIT ENTRAÎNER DES BLESSURES
GRAVES.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may
make design changes which do not diminish their performance or visual appeal and supplying them in such state
shall conform to the order. The Buyer acknowledges no representation or warranty (other than as to title) has
been given or will apply to the Products other than those in R&G's order or confirmation and the Buyer confirms it
has chosen the Products as being of merchantable quality and suitable for its particular purposes. Where R&G fits
the Products or undertakes other services it shall exercise reasonable skill and care and rectify any fault free of
charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on
the motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall at its
option either supply a replacement or refund the purchase money but shall not be liable if the Products have been
modified or used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good
engineering practice or if the defect arises from accident or neglect. Other than identified above and subject to
R&G not limiting its liability for causing death and personal injury, it shall not be liable for indirect or consequential
loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or the fitting or
service concerned. These terms do not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned
direct to us if they were purchased direct from us (customer must prove if necessary). Otherwise to be returned
to original vendor. Goods must be in re-sellable condition, in the opinion of R&G Racing. All returns are subject to
a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of
purchase). The customer must pay any and all carriage charges. No returns of discontinued products, unless
within 14 days of purchase. This policy does not affect your statutory rights and does not refer to faulty goods.
Unit
Tel: +44 (0) 420 89007 Fax: +44 (0)
1
ISSUE 1 - 02/07/2021 - (WW)
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
1
420 87301 www.rg-racing.com Email: info@rg-racing.com
1
R&G
LP0308