Atag ES1011QAM Notice D'utilisation page 70

MAINTENANCE
1
2
1
2
GB 10
Removing cassette filter
1 Switch off the motor and lighting.
2 Open the access hatch.
3 Remove the filter from the hood.
Cleaning
The filters can be cleaned in the dishwasher. Allow the filters to drain
well before replacing.
The filters can also be cleaned by hand.
Clean the filters in soapy water with washing up liquid and rinse.
Allow the filters to drain well. The underside of the cooker hood can
be cleaned with a mild cleaning agent and a damp cloth. Dry off with
kitchen paper or a dry tea towel.
Replacing cassette filter
The filter should be placed with the locking mechanism on the side.
Open the filter access hatch. The notches at the side of the filter will then
slot in. Hold the access hatch in this position when placing the filters.
1 Slot the notches at the back of the filter in the specially designed
opening to the side of the cooker hood.
2 Tilt the filter upwards.
3 Release the filter access hatch. The notches at the back of the
filter will extend outwards and slot into the specially designed
openings of the cooker hood.
The filter is now in position again.
Please note!
Replace the grease filters in their original assembled position (see figure).
Positioning the grease filters correctly ensures the most efficient extraction.