Voice Guide - Kenwood NEXEDGE NX-200 Mode D'emploi

• If there is memory available on your transceiver, "I am not
available. Leave your Message." will be sent to the caller
and they can leave you a recorded message. When a
message is stored on your transceiver, "NEW MESSAGE"
appears on the display.
• If no memory is available on your transceiver, "I am not
available" will be sent to the caller and "MEMORY FULL"
appears on the display.
■ Playback
(NX-200/300/200G/300G/205G/305G Only)
To play back a recorded conversation, memo, or message:
1 Press the key programmed as Playback or access the
Menu {page 15}.
• If the last action on your transceiver was to auto record
your conversation, "STORE?" will appear on the display,
otherwise a recording channel with the time of the
recording will appear.
2 Press
• "AR" represents auto recorded conversations, "RM"
represents auto reply messages, and "VM" represents
voice memos.
3 The transceiver will announce the time and channel,
then the recording will play back.
• When the entire recording has been played, "END OF
MESSAGE" is displayed. You can also end the recording at
any time by pressing
• To delete the selected recording, press
recorded data, press and hold

VOICE GUIDE

When changing the zone and/or channel, an audio voice will
announce the new zone and channel. Additionally, when
changing a function setting, the new setting will be announced.
Note: Voice announcements vary by dealer setting.
/ to select the channel you want to play.
.
.
. To clear all the
33