Compander; Busy Channel Lockout (Bcl); Control Channel Hunt; Ptt Id - Kenwood NEXEDGE NX-200 Mode D'emploi

Strong
flashes when out of range (NXDN Trunking only).

COMPANDER

If programmed by your dealer for a channel, the compander will
remove excessive noise from transmitted signals, to provide
higher clarity of signals.
Note: PTT ID can be made only in analog operation.

BUSY CHANNEL LOCKOUT (BCL)

On Conventional channels, if BCL is set up by your dealer, you
will be unable to transmit if the channel is already in use. Use
a different channel or wait until the channel becomes free.
If BCL Override has been programmed, you can transmit over
the current signal:
1 Press and hold the PTT switch.
• If the channel is already in use, a warning tone will sound.
2 Quickly release and then press the PTT switch again.
3 Speak into the transceiver as you would during a normal call.

CONTROL CHANNEL HUNT

On digital Trunking channels, the transceiver automatically
searches for a control channel.
• While searching for a control channel, the antenna icon will flash
(NX-200/300/200G/300G/205G/305G Only) and no signals can be
received.

PTT ID

PTT ID is the transceiver unique ID code which is sent each
time the PTT switch is pressed and/or released.
Note: PTT ID can be made only in analog operation.
Sufficient Weak Very weak
31