RIDGID R4514T Manuel D'utilisation page 49

ADJUSTMENTS
TO CHECK THE TIGHTNESS OF THE RIP FENCE
LOCKING LEVER
See Figure 74.
The locking lever on the rip fence should hold the rip fence
securely against the front and back rails. The lever should
not be difficult to push down and lock. To assure proper
fence lock adjustment:
 Lock the rip fence in place.
 Try moving the fence from side-to-side. If the fence moves,
tighten the lock nut 1/4 turn at a time, rechecking for
movement after each adjustment.
 With the rip fence in the locked position, recheck rip fence
parallelism with the blade and adjust if necessary.
NOTE: If it is difficult or too easy to lock and unlock the
locking lever, adjust the lock nut until the lever is properly
tensioned then repeat the above steps.
TO ADJUST THE BEVEL LOCKING LEVER
See Figure 75.
 Release bevel locking lever and bevel saw blade to 45º.
 Push bevel locking lever to lock blade into place.
 With moderate force, attempt to move the bevel adjusting
handwheel toward the 0º bevel.
 If bevel adjusting handwheel cannot be moved, no
adjustment is needed. If handwheel can be moved, adjust
the bevel lock nut by rotating clockwise 1/4 turn.
 Repeat above step as necessary.
 Release bevel locking lever and move bevel adjusting
handwheel back to 0º.
ADJUSTING
NUT
BEVEL
LOCK NUT
49 − English
Fig. 74
Fig. 75