RIDGID R4514T Manuel D'utilisation page 17

ASSEMBLY
 With the curve handle turned downward, secure the upper
tubes to the leg stand using carriage bolt (M8 x 80 mm),
small spacers, and lock nuts (M8).
 Remove the bolts, spacers, and lock nuts from the foot
assemblies.
 Place the feet onto the leg stand. Align the holes in the
feet with the holes in the leg stand.
 Slide a spacer onto each bolt and insert bolts through
the holes in the feet and leg stand.
 Install nuts and loosely tighten.
LOCK
NUT
CARRIAGE
BOLT
LEG STAND
NUT
FOOT
SPACER
BOLT
UPPER
TUBE
SMALL
SPACER
SMALL
SPACER
Fig. 10
Fig. 11
17 − English
 Slide the flat washer (ID13.5 x OD32 x 1.6t), wheel, and
flat washer (ID10 x OD18 x 1.6t) onto the axle through
the hole in the center of the wheel. Secure in place using
lock nut (M8).
 Repeat with the second wheel.
 Before use, verify the release lever locks the leg stand
securely and tighten all screws. If the leg stand will not
lock, do not use; contact an authorized service center for
assistance.
WHEEL
FLAT WASHER,
LOCK
SMALL
NUT
FLAT WASHER,
LARGE
RELEASE
LEVER
Fig. 12
CENTER
BRACE
Fig. 13