Télécharger Imprimer la page

Kärcher HDS 6/12 C Mode D'emploi page 31

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 42
Adjust cleaning temperature
 Set device switch to desired tempera-
ture.
30 °C to 98 °C
Clean with hot water.
100 °C to 150 °C
Clean using steam.
 Replace the high-pressure nozzle
(stainless steel) with steam nozzle
(brass), (refer to "Using steam").
Set working pressure and flow rate
Pressure/quantity regulation of the
pump unit
 Turn the regulation spindle in a clock-
wise direction: Increase working pres-
sure (MAX).
 Turn the regulation spindle in an anti-
clockwise direction: Reduce working
pressure (MIN).
Pressure/ quantity regulation at the
hand spray gun
 Set device switch to max. 98 °C.
 Set the operating pressure on the pump
unit to the maximum value.
 Set the working pressure and feed
quantity by turning (steplessly) the
pressure/quantity regulation mecha-
nism at the hand spray gun (+/-).
Danger
When adjusting the pressure/quantity regu-
lation, make sure that the screw connection
of the spray lance does not become loose.
Note: For long term work with low pres-
sure, set pressure at the pump unit.
Operation with detergent
For considerate treatment of the envi-
ronment use detergent economically.
The detergent must be suitable for the
surface to be cleaned.
 With support of the detergent dose
valve set detergent concentration as
determined by the manufacturer.
Note: Recommended values at the control
panel at maximum working pressure.
Note: If detergent is be suctioned from an
external container, route the detergent suc-
tion hose through the recess to the outside.
 Set pressure/temperature and deter-
gent concentration according to the sur-
face to be cleaned.
Note: To prevent damage due to too much
pressure, always position high pressure ray
first from a greater distance towards object
to be cleaned.
Recommended cleaning method
Loosen the dirt:
 Spray detergent economically and let it
work for 1...5 minutes but do not let it
dry up.
Remove the dirt:
 Spray off loosened dirt with the high-
pressure jet.
Operating with cold water
Removal of light contaminations and clear
rinse, i.e.: Gardening tools, terrace, tools, etc.
 Set operating pressure according to
need.
The appliance works in the most economi-
cal temperature range (max. 60°C).
– 7
EN
Cleaning
Eco level
31

Publicité

loading