Garland 20V 290 F Manuel D'instructions page 46

English
Clean the work area and remove all obstacles that may
cause accidents. Check the work area when going to
work and remove all items that could become entangled
in the cutting tool. Also remove all the objects that the
cutting tool can violently eject in the operation.
Do not allow anybody inside the working area. The
minimum perimeter of the working area is 15 m and
you must consider this a dangerous area.
Never use the machine when on top of a ladder, in a
tree or in any other unstable surface. Do not use the
chainsaw one handed.
You must turn off the engine when you are moving
between work areas.
Never let the machine out of your eyesight.
Do not use other accessories this machine except
those recommended by our company since its use
could cause severe damage to the user, people close
to the machine and the machine itself.
Always follow all security norms described in this
manual.
Verify the state of the tree prior to cutting to ensure
that dry branches will not fall off on top of you whilst
cutting.
Whilst cutting, ensure that the tip of the bar does not
come into contact with any trunks or other obstacles.
Maintain the chain always well sharpened. Sharpen as
described in this manual.
Never let the machine drop and never try to stop the
chain by closing in on a piece of wood or any other
object.
If you carry out several cuts without letting go of the
machine, always turn off the machine between cuts.
7.1. HOLDING THE MACHINE
Place the holding belt as shown in the image and click
onto the machine using the ring.
Hold the machine with the left hand on the handle and
with the right hand on the top handle in such a way
that you can act over the control switches (accelerator
and security switch) with your right hand.
Attention!: So as to reduce the risk of loss of control
and possible damages (that could be mortal) to the
user or those surrounding him, never use the machine
one handed.
Always maintain both feet on the ground and only
action the pruner saw when you are on a flat and
stable surface. Maintain your body on the left side of
the machine. Maintain the pole saw at a maximum 60
degrees from the ground and maintain an adequate
safety distance from the branch being cut.
60º max.
46/140