Télécharger Imprimer la page

Power Fist 9136854 Manuel De L'utilisateur page 14

Clé à chocs pneumatique tronquée en composite à prise de 1/2 po

Publicité

Les langues disponibles

Les langues disponibles

9136854
Problem(s)
Tool runs slowly.
Air flows slightly
from exhaust.
And/Or
Air flows slightly
from nozzle.
Tools will not run.
Air flows freely
from exhaust.
Tool will not shut
off.
Loss of power
or erratic
performance.
www.princessauto.com / 1-800-665-8685
IMPACT WRENCH
Possible Cause(s)
1.
Motor parts jammed
with dirt particles.
OR
Airflow blocked by
dirt.
2.
Air regulator in closed
position.
3.
Air flow or air
pressure is too low.
4.
Damage or excessive
wearing of internal
parts.
1.
Damage or excessive
wearing of internal
parts.
2.
Insufficient internal
lubrication.
1.
Throttle valve o-ring
dislodged from inlet
valve seat.
2.
Trigger mechanism
jammed or dirty.
1.
Excessive drain on
the air hose. Incorrect
size or type of hose
connectors.
2.
Moisture or restriction
in the air hose/tank
3.
Air compressor has
insufficient flow.
Suggested Solution(s)
1.
Check air inlet filter for blockage.
a.
Pour air tool lubricating
oil into air inlet as per
lubrication instructions for
clearing shipping grease.
b.
Operate tool in short bursts to
clear debris.
c.
If tool still jammed, clean tool
and lubricate per lubrication
instructions.
2.
Open the air regulator to the
desired airflow.
3.
Adjust air flow or air pressure
to match tool requirements (see
Specifications).
4.
Have a qualified technician service
the tool.
a.
Replace tool or parts.
1.
Have a qualified technician service
the tool.
2.
Replace tool or parts.
3.
Lubricate tool per air tool
lubrication instructions.
1.
Replace throttle valve o-rings.
2.
Clean trigger mechanism and
lubricate.
1.
Check the air hose and confirm the
hose fitting is correct for the inlet
bushing.
2.
Depressurize system and drain
tank and air hose of water.
3.
Ensure tool is connected to a
compressor with a rate flow that
matches the tool.
V1.0
Page 14

Publicité

loading