Publicité
Les langues disponibles
Les langues disponibles
9136854
4.
Keep the tool handles or gripping surfaces clean and dry.
5.
Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd.
for replacements.
6.
Clear the vents of any dirt, dust and debris on a regular basis to
prevent the tool from overheating.
WARNING! Only qualified service personnel should repair
the tool. An improperly repaired tool may present a hazard
to the user and/or others.
CLEANING
1.
Remove dust and debris from the motor's vents with a cloth, brush
or vacuum. Do not use compressed air, as it may blow dust into
the motor.
2.
Only clean with a damp cloth. Avoid using solvents when cleaning
plastic parts.
AIR TOOL LUBRICATION
NOTICE! Only use air tool oil to lubricate the tool. Other
lubricants are not suitable and will damage the tool or cause
a malfunction during use.
NOTICE! Never use a penetrating oil to lubricate an air tool.
Penetrating oil acts as a solvent that will dissolve the tool's
grease packing and may damage the o-rings, causing the
tool to seize or malfunction.
1.
All air tools have an internal coating of grease to prevent corrosion
during shipping and storage. Remove this grease by adding a
generous amount of air tool oil in the air inlet and then run the tool
under no load until the exhaust is clear.
2.
Manually add a drop or two of air tool oil into the tool's coupler
plug before each use and after every hour of continuous use. The
tool will not work properly without lubrication and parts will wear
prematurely.
3.
Avoid adding too much air tool oil as this can cause premature
power loss and eventual tool failure. A qualified technician will
need to take the tool apart and clean out the excess oil.
4.
Apply a generous amount of air tool oil to the tool before storing
it for an extended period of time (overnight, weekend, etc.). Run
www.princessauto.com / 1-800-665-8685
IMPACT WRENCH
V1.0
Page 12
Publicité
