Horizon Hobby Blade 150 FX RTF Manuel D'utilisation page 5

Installing the Transmitter Batteries
The LED indicator flashes and the transmitter beeps
as the battery voltage drops.
Replace the 4 AA transmitter batteries when the
blue LED on the transmitter begins to flash.
Transmitter Control
Dual Rate
Switch
A
B
C
A
Rudder (Left/Right)
Mode 1
Elevator (Up/Down)
Rudder (Left/Right)
Mode 2
Throttle (Up/Down)
Throttle Cut
LED Power
indicator
ON/OFF Switch
B
Elevator Trim
Throttle Trim
Dual Rate Selection
The control sensitivity can be changed by setting the Dual Rate
switch. Select between high and low rates (Hi/Lo).
Switch We recommend starting with low rates.
Throttle Cut
Throttle cut is used to prevent accidental motor operation before
flight, and to turn the motor off quickly if the helicopter is out of
control.
The motor will stop spinning and not respond to throttle stick
commands when the throttle cut is switched to the red dot
position.
When throttle cut is switched to the green dot position the motor
F
will continue to spin at low idle speed and will respond to throttle
E
commands.
If throttle cut is switched to the green dot position and the throttle
D
position is not at lowest position, the motor will spin at low idle
speed but will not respond to throttle control until the throttle is
lowered to the lowest setting.
Adjusting Flight Trims
The transmitter beeps every time one of the trim buttons is
pressed, until the trim has reached the upper or lower range
limit. The middle or neutral trim position is heard as a longer
tone. The end of the trim range is indicated by no sound when
the button is pressed.
C D
Rudder Trim Aileron Trim
Rudder Trim Aileron Trim
5
E
Aileron (Left/Right)
Throttle Trim
Throttle (Up/Down)
Aileron (Left/Right)
Elevator Trim
Elevator (Up/Down)
F
EN