GYS STARTIUM 480E Mode D'emploi page 7

This manual contains safety and operating instructions. Read it carefully before using the device for the first time and
keep it in a safe place for future reference.
GENERAL DESCRIPTION
STARTIUM devices are designed for charging and starting 12V (6 element) and 24V (12 element) lead acid batteries
(electrolyte, gel and AGM) :
Assembly - handle and wheels (only for the 480E, 680E & 980E) :
POWER SUPPLY
Check that the power and protection (fuse and / or circuit breaker) are compatible with the current required. The
appliance must be positioned so that the plug socket is accessible.
It must be connected to a grounded outlet according to the following recommendation:
Power supply
Protection
Charge power
Start power
12V
Capacity
24V
*In the event that starting a large vehicle is troublesome it may be necessary to fit a 20A plug (not included).
Recommended cable section in case of extension lead : 3 x 2.5 mm².
CONNECTION AND DISCONNECTION
IMPORTANT! Before connecting to a battery, check that the device is not connected to the power supply and the switch
is OFF.
Secondly, check the polarity of your battery (the fuse breaks if the polarity has been reversed).
Attention: The cables must not be pinched or in contact with hot or sharp surfaces.
Starting and charging a battery connected on the vehicle :
Where the negative pole of the battery is connected to the vehicle chassis
• Connect the red clamp to the positive pole of the battery.
• Connect the black clamp to the vehicle chassis, ensure it is not close to fuel lines and the battery.
• Connect the device to the mains.
• After use, turn the switch to OFF (if any), then disconnect the charger from the mains supply then disconnect the black
clamp and finally the red clamp.
Some vehicles have the positive pole of the battery connected to the chassis, in this case:
• Connect the black clamp to the negative terminal of the battery.
• Connect the red clamp to the vehicle chassis, ensure it is not close to fuel lines and battery.
• Connect the device to the mains.
• After use, turn the switch to OFF (if any), then disconnect the charger from the mains supply then disconnect the red
clamp and finally the black clamp.
STARTIUM 330E / 480E / 680E / 980E
STARTIUM 330E STARTIUM 480E
230V - 1 ph
16 A
800 W
6 500 W
20 - 375 Ah
20 - 300 Ah
STARTIUM 680E
230V - 1 ph 230V - 1 ph
16 A
1 700 W
9 000 W 10 000 W
20 - 600 Ah 20 - 675 Ah
20 - 450 Ah 20 - 525 Ah
STARTIUM 980E
230V - 1 ph
16 A
2 000 W 2 000 W
12 000 W
20 - 750 Ah
20 - 525 Ah
EN
16 A*
7