Publicité
Les langues disponibles
Les langues disponibles
6.1 Use of the 230V AC socket
NOTE: Do not start the generator with loads connected. Disconnect them
from the panel or are sure the switches of equipment are in "OFF" position, so that
the generator starts without loads
Start the engine following the steps indicated in this manual.
Once started, verify that the "BREAKER" is in the "ON" position as below picture,
now you can connect your devices.
WARNING: Confirm that all electrical devices are in good conditions before
plugging them to the generator.
If an electrical device is not working properly, is slow or stops suddenly, turn off
the engine immediately and unplug the device.
6.2 Generator overload and restart
In case of an overload or short circuit the overload protection "BREAKER" will
switch to the "OFF" position, disconnecting the voltage output.
In case of overload, first unplug any plugged equipment. Once the equipment are
unplugged, assemble the overload protector again by rising the protector to the
"ON" position to restore the group voltage output.
If the overload protector trips again after connecting the devices, do not plug the
device. The plugged device may have a problem or exceeds the generator's
power.
NOTE: Once you verify that the generator cannot support or accept the load,
please do not insist. Constant overloads may negatively affect the group
connected.
49
.
Publicité
