Publicité
Les langues disponibles
Les langues disponibles
4.2 Transportation kit assembly
Fix the wheels according to the lower figure: washer (4) Cross the wheel (2) with the
shaft (3), pass the end of the shaft through the hole provided in the generator frame for
this purpose. Finally fix the shaft with the pin
Fix the transport wheels and support feet
according to the figure on the right.
Attach the rubber feet (4) to the bracket foot (3)
using the M6x18 screws (5) and the M6 nuts
(2).
Once the bracket foot is assembled, fix it to the
machine frame using the M8 x18 screws (6)
and the M8 nuts (1).
(1).
Fix the handles according to the
figure on the left.
Thread the bolt (5) through the
mounting hole of the handle (1) and
the frame, and fix them with a nut (6)
.
Put the spring pin (2) through the
mounting hole of the handle (1) and
the frame, and fix them with washers
(3) and circlip (4) to limit the handle.
40
Publicité
