Introduction; Description; Safety Information - Honeywell E3 Point Manuel D'utilisation

Description

3
The E Point Remote Sensor is a toxic or combustible gas detection
sensor that is compatible with the E
the features offered in certain controller type products, such as the
301C. It provides continuous monitoring for one of the following gases
in ambient air: CO, H
3
The E Point is designed to be mounted on an extra wide (2 3/8")
electrical box.
3
The E Point Remote Sensor is intended for use exclusively with the
3
E Point Standalone unit. No other uses are supported by Honeywell
Analytics.

Safety Information

Users of the E
the installation, operating, and maintenance instructions, otherwise
protection provided by the monitor may be impaired. Read the
following warnings before using the monitor.
WARNING:
•
•
•
•
•
•
•
•
•
3
E Point Remote Gas Sensor User Manual

Introduction

S, O , NO
2 2
3
Point Remote Sensor require a full understanding of
Install according to local electrical regulations and codes.
Installation should be performed by qualified personnel.
Do not paint over the sensor screen.
Ensure the sensor screen is free of dirt and debris.
Ensure the sensor screen is not covered.
Do not expose the monitor to electrical shock and/or continuous
mechanical shock.
Do not expose the sensor to high pressure water spray.
Do not use the monitor if it is damaged. Before use inspect the
monitor. Look for cracks, missing metals, or plastics. If the monitor
is damaged, contact Honeywell Analytics immediately.
The warranty will be voided if the customer or any unauthorized
service personnel attempts to repair the unit.
3
Point Standalone sensor or with
, and combustible hazards.
2
1