Publicité
Les langues disponibles
Les langues disponibles
FOR YOUR SAFETY READ BEFORE LIGHTING
WarninG: If you do not follow these instructions exactly, a fire or explo-
sion may result causing property damage, personal injury or loss of life.
a. this appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instructions
exactly.
B. BeFore liGHtinG smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the
floor.
WHat to Do iF You sMell Gas
• Do not try to light any appliance.
• Do not touch any electrical switch;
do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
1.
STOP! Read the safety information above.
2.
Set the thermostat to lowest setting.
3.
Turn off all electric power to the appliance (if appli-
cable).
4.
Remove control access panel (front panel).
5.
Push in gas control knob slightly and turn clockwise
NOTE: Knob cannot be turned from "PILOT" to "OFF"
unless knob is pushed in slightly. Do not force.
6. Wait ten (10) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas, STOP!
Follow "B" in the safety information above. If you don't
smell gas, go to the next step.
7. Remove the pilot access cover located on the combustion
chamber.
8. Find pilot - follow metal tube
from gas control. The pilot is
behind the pilot access cover.
1. Set the thermostat to lowest setting.
2. Turn off all electric power to appliance if service is to be
performed (if applicable).
3. Remove control access panel (front panel).
12433-11-0709
liGHtinG instructions
LIGHTING INSTRUCTIONS
to "OFF".
PILOT
THERMOPILE
BURNER
TO TURN OFF GAS TO APPLIANCE
• If you cannot reach your gas supplier, call the
fire department.
c. use only your hand to push in or turn the gas control
knob. never use tools. if the knob will not push in
or turn by hand, don't try to repair it; call a quali-
fied service technician. Force or attempted repair
may result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service techni-
cian to inspect the appliance and to replace any part
of the control system and any gas control which has
been under water.
9. Turn knob on gas control counterclockwise
to "PILOT."
10. Push in control knob all the way and hold in. Imme-
diately light the pilot with the Piezo Pilot Ignitor or a
match. Continue to hold the control knob in for about
one (1) minute after the pilot is lit. Release knob, and
it will pop back up. Pilot should remain lit. If it goes
out, repeat steps 5 through 10.
• If knob does not pop up when released, stop
and immediately call your service technician
or gas supplier.
• If the pilot will not stay lit after several tries,
turn the gas control knob to "OFF" and call
your service technician or gas supplier.
11. Replace pilot access cover.
12. Turn gas control knob counterclockwise
"ON."
13. Replace control access panel (front panel).
14. Turn on all electric power to the appliance (if appli-
cable).
15. Set thermostat to desired setting.
16. CAUTION: Pilot access cover must be kept tightly
closed during operation.
4.
Push in gas control knob slightly and turn clockwise
to "OFF." Do not force.
5.
Replace control access panel (front panel).
to
Page 11
Publicité
