Dräger X-plore 6000 Notice D'utilisation page 10

en |
Safety-related information
1 Safety-related information
– Before using this product, carefully read these instructions for use and those
of the associated products.
– Strictly follow the instructions for use. The user must fully understand and
strictly observe the instructions. Use the product only for the purposes
specified in the intended use section of this document.
– Do not dispose of the instructions for use. Ensure that they are stored and
used appropriately by the user.
– Only trained and competent users are permitted to use this product.
– Do not use a faulty or incomplete product. Do not modify the product.
– Notify Dräger in the event of any component fault or failure.
– Comply with all local and national rules and regulations associated with this
product.
– Only trained and competent personnel are permitted to inspect, repair and
service the product. Dräger recommend a Dräger service contract for all
maintenance activities and that all repairs are carried out by Dräger.
– Use only genuine Dräger spare parts and accessories. Otherwise, the
proper functioning of the product may be impaired.
2 Conventions in this document
2.1 Meaning of the warning notices
The following warning notices are used in this document to alert the user to
potential hazards. The meanings of the warning notices are defined as follows:
Warning sign Signal word
WARNING
CAUTION
10
Classification of the warning notice
Indicates a potentially hazardous situa-
tion. If not avoided, it could result in
death or serious injury.
Indicates a potentially hazardous situa-
tion. If not avoided, it could result in
physical injury. It may also be used to
alert against unsafe practices.
Warning sign Signal word
NOTICE
3 Description
3.1 Product overview (see fold-out page,
Figure A)
1
Mask connector
2 Control valve
3 Inner mask
4 Visor
5 Visor frame
6 Upper head-harness connector 12
3.2 Feature description
The full face masks have a round-thread connector according to EN 148-1. This
makes the full face masks suitable for respiratory filters, powered air purifying
respirators and airline equipment with round-thread connectors according to
EN 148-1 (RA).
The full face masks can be used at temperatures from -30 °C to +60 °C.
Mask spectacles can be inserted for users who wear spectacles. A welding
protective visor can be optionally attached for full face masks with a metal
frame.
3.3 Intended use
The facepieces protect the face and eyes from aggressive media.
Instructions for use
Classification of the warning notice
Indicates a potentially hazardous situa-
tion. If not avoided, it could result in
damage to the product or environment.
7
Harness
8 Face seal
9 Carrying strap
10 Mask body
11 Clamping ring
Exhalation valve cover
|
Dräger X-plore 6000